The Liquid Volume Dispenser will deliver a measured volume of liquid at the press of a button. The operator selects a volume, presses a button and the Liquid Volume Dispenser delivers the required volume without further operator intervention.
Their are two versions of the Liquid Dispenser:
The Low Volume Liquid Dispenser, which will dispense between 0.025 liters and 10 liters and will accurately measure volumes over a flow rate range of between 0.2 and 2.5 liters/minute.
The Volume Liquid Dispenser which will dispense volumes between 0.10 liters and 100.00 liters can be selected in increments of 0.01 liters. The Dispenser will accurately measure volumes over a flow rate range of between 0.6 and 5 liters/minute.
The Liquid Volume Dispenser has two John Guest Speedfit® push-fit connectors for fluid in and out. These take a tube with outside diameter of 8mm. Wetted surfaces are nylon, PTFE, Buna and acetal, making the Liquid Volume Dispenser suitable for a wide range of fluids.
Operator controls consist of a three-button keypad and a liquid crystal display. The display shows the selected volume and progress during dispensing. A number of additional features are available through the keypad, including pause and restart during dispensing, cancelling dispensing, and manual ‘top-up’ control.
An audio ‘beep’ options is provided to indicate when dispensing has stopped. Another audio option will produce ‘beeps’ if the flow rate is outside the limits for accurate volume measurement. These audio options can be enabled or disabled through a display menu and are save to non-volatile memory, so are restored to the operator’s preference after power-up.
The Liquid Volume Dispenser is powered by a low-voltage supply, making it safe to use if liquid is spilt. A 12VDC mains socket adapter is supplied with each Dispenser.
The Dispenser can be connected to a PC for remote control and monitoring and is supplied with an easy-to-use software application that repeats the operator controls and displayed information.
(1) Potable water at 10C
(2) Potable water
(3) For soft or thin-walled tubing, tube inserts should be used
|Low Volume Liquid Dispenser Datasheet
|Liquid Dispenser Datasheet